Download app & create account

1. Download the ‘Enode’ app from the App Store of your choice. Select yourpathway (individual or organisation. Create a new account or use an existing one. Enter your email address. Depending on which route you are taking, there will be a different onboarding process.
2. A One-Time Password will be sent to your email address. You will need to enter this OTP to finalise the account setup.
3. Enter the app again to finally log in to your account.
4. Ensure that all Bluetooth and location settings are enabled for the Enode app.

Initial switch-on of the sensor

1. We ship the sensors in a switched-off state. Therefore, it is necessary to connect the sensor to a power source initially. Use the included micro USB cable for this purpose. Make sure to insert the cable in the correct position without force.
2. The sensor should start to flash continuously. This means that the sensor is charging.
3. It can be disconnected and used immediately if necessary.

Inserting the charging cable should not feel difficult at any time. As soon as you feel resistance, check if the cable is correctly aligned and inserted straight. The logo on the cable should be visible from above when plugged in. Please use only micro USB cables for charging. Do not use Lightning or USB Type-C cables for charging.

Connecting the sensor

1. Select ‘Connect sensor’. Make sure that the mobile device and the sensor are no more than 10 cm / 4 inches apart while doing so.
2. When both devices have found each other, it may happen that the sensor needs a calibration. To do this, place the sensor on each of the 6 sides for 1-2 seconds. Watch for the marker to disappear on the virtual sensor within the app.
3. The sensor should now be connected and ready to use.

Even though the sensor has been designed so that it can be used without the barbell strap,we recommend that you always use the barbell strap. On the one hand, this can have a positive effect on the measurement behavior and, on the other hand, it prevents the sensor from unintentionally detaching from the training device.

If you still have questions or would like to know something specific, you can always contact us or visit our Help Desk.